GGU-3D-TRANSIENT: "Display hydrographs" menu item
- Matthias Jusko
Once the time values have been read in, you will be asked which values you would like to have displayed at given points.
If you have assigned the same flow value to all node points, you can have the temporal development displayed for all activated nodes simultaneously by clicking the "All" button. This can be very advantageous if you would like to compare the changes at different regions in the system.
Following your selection, a dialog box appears, which is shown below with all nodes selected.
The box shows the minimum and maximum values at the node points. Using the "ASCII file" button, the data can be saved in a record that can be represented as a table, for example, in your word processor.
Using the"GGU-TIME-GRAPH" button in the two previous dialog boxes, you can save all time graph data in a file,".gis", and open them in the GGU-TIME-GRAPH program for further processing.
If you have only selected a single node for time graph visualisation, this button will export the data to a file with the extension ".gng". You can import this file into the editor for a single time graph curve in the GGU-TIME-GRAPH program using the "Load measured data" button.