GGU-3D-SSFLOW: "(Potentials) Linear" menu item

After going to this menu item you click the nodes of the FEM mesh to which a potential boundary condition is to be assigned. Press [Return] to then enter a start and an end potential and, if necessary, activate the "Apply to all" check box in order to apply the boundary conditions at the marked points for all planes

The selected node is assigned a potential which increases linearly from the start potential to the end potential, proportional to the separation of the nodes to each other. This menu item is helpful if you need to consider a water course, for example, the water level of which changes linearly within the system.